Receiver Access Control using PANA in IP Multicast
draft-atwood-mboned-mrac-pana-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | J. William Atwood , Bing Li , Salekul Islam | ||
| Last updated | 2015-04-30 (Latest revision 2014-10-27) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Multicast Receiver Access Control must be enforced at both the application level and at the network level. The control at the two levels must be correlated, to ensure that only a legitimate group member at the application level is permitted to join group at the network level. We assume that authentication and authorization at the application level are provided by Extensible Authentication Protocol (EAP) exchanges. We describe how to use Protocol for carrying Authentication for Network Access (PANA) to transport the EAP packets in such a way that authententication and authorization can be easily achieved at the network level and that the necessary coordination is achieved.
Authors
J. William Atwood
Bing Li
Salekul Islam
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)