Gateway-Initiated 4over6 Deployment
draft-chen-softwire-gw-init-4over6-02
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Yuchi Chen , Jianping Wu , Xiongyan Tang, Guangtao Zhou | ||
Last updated | 2014-03-03 (Latest revision 2013-08-27) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Gateway-Initiated 4over6 is a variant of Lightweight 4over6. A Lightweight B4 in Lightweight 4over6 mechanism is a router which acts as a tunnel initiator for the IPv4-in-IPv6 tunnel. This mechanism mainly focuses on the scenario in which an IPv4 address and related configuration information is configured to the device behind Lightweight B4. Gateway-Initiated 4over6 uses the full IPv4 address rather than a shared address. This enables an unmodified end server or host that is behind a Lightweight B4 to get access to the IPv4 Internet through an IPv6 network.
Authors
Yuchi Chen
Jianping Wu
Xiongyan Tang
Guangtao Zhou
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)