RADIUS Extensions for Port Set Configuration and Reporting
draft-cheng-behave-cgn-cfg-radius-ext-05
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
---|---|---|---|
Authors | Dean Cheng , Jouni Korhonen , Mohamed Boucadair , Senthil Sivakumar | ||
Last updated | 2013-11-22 (Latest revision 2013-05-21) | ||
Replaced by | draft-ietf-radext-ip-port-radius-ext, draft-cheng-radext-ip-port-radius-ext, RFC 8045 | ||
RFC stream | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines new RADIUS attributes that can be used by a device implementing port ranges to communicate with a RADIUS server to configure and/or report TCP/UDP port sets and ICMP identifiers mapping behavior for specific hosts. This mechanism can be used in various deployment scenarios such as CGN, NAT64, Provider WiFi Gateway, etc. This document does not make any assumption about the deployment context.
Authors
Dean Cheng
Jouni Korhonen
Mohamed Boucadair
Senthil Sivakumar
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)