ICCP extension for the MSP application
draft-hao-pwe3-iccp-extension-for-msp-04

 
Document
Type Expired Internet-Draft (individual)
Last updated 2013-04-25 (latest revision 2012-10-22)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
plain text pdf html
Stream
Stream state (No stream defined)
Document shepherd No shepherd assigned
IESG
IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

Email authors IPR References Referenced by Nits Search lists

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
//www.ietf.org/archive/id/draft-hao-pwe3-iccp-extension-for-msp-04.txt

Abstract

This document specifies extensions to the Inter-Chassis Communication Protocol (ICCP) to support inter-chassis linear multiplex section protection (MSP) as described in G.841 and automatic protection switching as defined in ANSI T1.105.01. This document considers an application where a CE device or access network is attached to two PEs through Synchronous Digital Hierarchy (SDH) circuits, and MSP or APS is used to protect the attachment circuits. ICCP is used to support configuration and state synchronization between two chassis. CE device or access network attached to more than two PEs is out of the scope of this document.

Authors

Hongjie Hao (hao.hongjie@zte.com.cn)
Ma Yuxia (ma.yuxia@zte.com.cn)
Weiqiang Cheng (chengweiqiang@chinamobile.com)
Daniel Cohn (daniel.cohn.ietf@gmail.com)
Masahiro Daikoku (ms-daikoku@kddi.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)