Skip to main content

Receiver Driven P2MP TE Requirements
draft-jacquenet-mpls-rd-p2mp-te-requirements-00

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
Authors Christian Jacquenet , Quintin Zhao
Last updated 2010-10-17
RFC stream (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document presents a set of requirements for the establishment and maintenance of receiver driven Point-to-Multipoint (P2MP) Traffic-Engineered (TE) Multiprotocol Label Switching (MPLS) Label Switched Paths (LSPs). There is no intent to specify solution-specific details or application-specific requirements in this document. The requirements presented in this document not only apply to packet- switched networks under the control of MPLS protocols, but also encompass the requirements of Layer Two Switching (L2SC), Time Division Multiplexing (TDM), lambda, and port switching networks managed by Generalized MPLS (GMPLS) protocols. Protocol solutions developed to meet the requirements set out in this document must attempt to be equally applicable to MPLS and GMPLS.

Authors

Christian Jacquenet
Quintin Zhao

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)