Composite Link Framework in Multi Protocol Label Switching (MPLS)
draft-so-yong-rtgwg-cl-framework-06
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Ning So , Dave McDysan , Eric Osborne , Lucy Yong , Curtis Villamizar | ||
Last updated | 2012-12-31 (Latest revision 2012-06-29) | ||
Replaced by | draft-ietf-rtgwg-cl-framework | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-rtgwg-cl-framework | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies a framework for support of composite link in MPLS networks. A composite link consists of a group of homogenous or non-homogenous links that have the same forward adjacency and can be considered as a single TE link or an IP link in routing. A composite link relies on its component links to carry the traffic over the composite link. Applicability is described for a single pair of MPLS-capable nodes, a sequence of MPLS-capable nodes, or a set of layer networks connecting MPLS-capable nodes.
Authors
Ning So
Dave McDysan
Eric Osborne
Lucy Yong
Curtis Villamizar
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)