RTP Payload Format for SVC Video
draft-wenger-avt-rtp-svc-03
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Stephan Wenger | ||
| Last updated | 2008-04-17 (Latest revision 2006-10-20) | ||
| Replaced by | draft-ietf-avt-rtp-svc | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-avt-rtp-svc | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo describes an RTP Payload format for the scalable extension of the ITU-T Recommendation H.264 video codec which is the technically identical to ISO/IEC International Standard 14496-10 video codec. The RTP payload format allows for packetization of one or more Network Abstraction Layer Units (NALUs), produced by the video encoder, in each RTP payload. The payload format has wide applicability, as it supports applications from simple low bit-rate conversational usage, to Internet video streaming with interleaved transmission, to high bit-rate video-on-demand.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)