Network Working Group R. Stewart
Request for Comments: 5354 Q. Xie
Category: Experimental The Resource Group
M. Stillman
Nokia
M. Tuexen
Muenster Univ. of Applied Sciences
September 2008
Aggregate Server Access Protocol (ASAP) and
Endpoint Handlespace Redundancy Protocol (ENRP) Parameters
Status of This Memo
This memo defines an Experimental Protocol for the Internet
community. It does not specify an Internet standard of any kind.
Discussion and suggestions for improvement are requested.
Distribution of this memo is unlimited.
Abstract
This document details the parameters of the Aggregate Server Access
Protocol (ASAP) and Endpoint Handlespace Redundancy Protocol (ENRP)
defined within the Reliable Server Pooling (RSerPool) architecture.
Stewart, et al. Experimental [Page 1]
RFC 5354 ASAP & ENRP Common Parameters September 2008
Table of Contents
1. Introduction ....................................................3
1.1. Conventions ................................................3
2. Parameters in General ...........................................3
3. ENRP-ASAP Common Parameters .....................................3
3.1. IPv4 Address Parameter .....................................6
3.2. IPv6 Address Parameter .....................................6
3.3. DCCP Transport Parameter ...................................7
3.4. SCTP Transport Parameter ...................................8
3.5. TCP Transport Parameter ....................................9
3.6. UDP Transport Parameter ....................................9
3.7. UDP-Lite Transport Parameter ..............................10
3.8. Pool Member Selection Policy Parameter ....................11
3.9. Pool Handle Parameter .....................................12
3.10. Pool Element Parameter ...................................12
3.11. Server Information Parameter .............................13
3.12. Operation Error Parameter ................................14
3.12.1. Unspecified Error .................................15
3.12.2. Unrecognized Parameter Error ......................15
3.12.3. Unrecognized Message Error ........................15
3.12.4. Invalid Values Error ..............................16
3.12.5. Non-Unique PE Identifier Error ....................16
3.12.6. Inconsistent Pool Policy Error ....................16
3.12.7. Lack of Resources Error ...........................16
3.12.8. Inconsistent Transport Type Error .................16
3.12.9. Inconsistent Data/Control Configuration Error .....16
3.12.10. Rejected Due to Security Considerations ..........16
3.12.11. Unknown Pool Handle Error ........................17
3.13. Cookie Parameter .........................................17
3.14. PE Identifier Parameter ..................................17
3.15. PE Checksum Parameter ....................................18
3.16. Opaque Transport Parameter ...............................18
4. Common Message Formats .........................................18
5. IANA Considerations ............................................20
5.1. A New Table for RSerPool Parameter Types ..................20
5.2. A New Table for RSerPool Error Causes .....................21
6. Security Considerations ........................................21
7. Normative References ...........................................21
Stewart, et al. Experimental [Page 2]
RFC 5354 ASAP & ENRP Common Parameters September 2008
1. Introduction
The Aggregate Server Access Protocol (ASAP) [RFC5352], in conjunction
with the Endpoint Handlespace Redundancy Protocol (ENRP) [RFC5353],
provides a high-availability, data-transfer mechanism over IP
networks.
Both protocols work together and so share many common parameters used
in message formats. This document details the common message
parameters shared between the two protocols. This document provides
parameter formats only; for procedures and message composition,
please refer to the respective [RFC5352] and [RFC5353] documents.