Skip to main content

Traffic Engineering Architecture and Signaling

The information below is for an older proposed charter
Document Proposed charter Traffic Engineering Architecture and Signaling WG (teas) Snapshot
Title Traffic Engineering Architecture and Signaling
Last updated 2014-11-19
State Start Chartering/Rechartering (Internal Steering Group/IAB Review) Rechartering
WG State Proposed
IESG Responsible AD John Scudder
Charter edit AD Adrian Farrel
Send notices to (None)

The Traffic Engineering Architecture and Signaling (TEAS) Working
Group is responsible for defining MPLS and GMPLS traffic 
engineering architecture, standardizing the RSVP-TE signaling
protocol, and identifying required related control-protocol 
functions, i.e., routing and path computation element functions. 

Traffic Engineering (TE) is the term used to refer to techniques
that enable operators to control how specific traffic flows are 
treated within their networks. TE is applied to packet networks 
via MPLS TE tunnels and LSPs. The MPLS-TE control plane was
generalized to additionally support non-packet technologies via
GMPLS.  RSVP-TE is the signaling protocol used for both MPLS-TE
and GMPLS.

The TEAS WG will work on the following topics:

 a) Traffic-engineering architectures for generic applicability
    across packet and non-packet networks. This includes both 
    networks that include the use of PCE and those that do not.
    The PCE architecture itself is out of the WG scope.

 b) Definition of protocol-independent metrics and parameters 
    (measurement and/or service attributes) for describing 
    links and tunnels/paths required for traffic engineering
    (and related routing, signaling and path computation). 
    These will be developed in conjunction with requests and
    requirements from other WGs to ensure overall usefulness.

 c) Functional specification of extensions for routing (OSPF,
    ISIS) and for path computation (PCE) to provide general 
    enablers of traffic-engineering systems that also use 
    RSVP-TE. Protocol formats and procedures that embody these
    extensions will be done in coordination with the WGs 
    supervising those protocols.

 d) Functional specification of generic (i.e., not data plane
    technology-specific) extensions for RSVP-TE, and the 
    associated protocol formats and procedures that embody 
    these extensions. 

 e) Define control plane mechanisms and extensions to allow the
    setup and maintenance of TE paths and TE tunnels that span 
    multiple domains and/or switching technologies, where a 
    domain may be an IGP area, an Autonomous System, or any other
    region of topological visibility. 

 f) Define and extend management and security techniques for 
    RSVP-TE signaling. This includes YANG and MIB modules for
    configuring and monitoring RSVP-TE as well as mechanisms used
    to configure, control, and report OAM within TE networks. 

The TEAS working group is chartered to deliver the following:

 1. Definition of additional abstract service, link, and path 
    properties such as jitter, delay, and diversity. Extensions 
    to IGPs to advertise these properties, and extensions to 
    RSVP-TE to request and to accumulate these properties. Work
    with PCE WG to include these properties in computation 

 2. Specification of terminology, architecture, and protocol
    requirements for abstraction and distribution of TE 
    information between interconnected TE domains/layers.

 3. Specification and protocol extensions for a GMPLS External
    Network-to-Network Interface (E-NNI), i.e., multi-domain 
    GMPLS support.

 4. Protocol mechanisms to signal associated LSPs in particular
    with different source nodes.

 5. Requirements and protocol extensions for additional protection
    mechanisms including end-point protection, protection of P2MP 
    LSPs, and inter-domain protection.

 6. YANG models for a Traffic Engineering Database in coordination
    with working groups working on YANG models for network
    topology and for technology-specific network attributes.

The TEAS WG will coordinate with the following working groups:

 - With the MPLS WG to maintain and extend MPLS-TE protocol
   mechanisms and to determine whether they should be generalized.
 - With the CCAMP WG to maintain and extend non-packet, data plane
   technology-specific TE protocol mechanisms and to determine 
   whether they should be generalized.

 - With the OSPF and ISIS WGs to maintain or extend TE routing 
   mechanisms for MPLS-TE and GMPLS.

 - With the PCE WG on uses of a PCE in the traffic-engineering 
   architecture, on PCE extensions per the above, and on RSVP-TE
   extensions to support PCE WG identified requirements.

 - With the IDR WG on the use of BGP-LS in TE environments.

In doing this work, the WG will cooperate with external SDOs (such
as the ITU-T and the IEEE 802.1) as necessary.