Standardized interval support in BFD
draft-akiya-bfd-intervals-03
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
---|---|---|---|
Authors | Nobo Akiya , Marc Binderberger | ||
Last updated | 2013-01-17 (Latest revision 2012-07-16) | ||
RFC stream | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines a set of interval values that we call "Standard intervals". Values of this set must be supported for transmitting BFD control packets and for calculating the detection time in the receive direction when the value is equal or larger than the fastest, i.e. lowest, interval a particular BFD implementation supports. This solves the problem of finding an interval value that both BFD speakers can support while allowing a simplified implementation as seen for hardware-based BFD.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)