SIIT-DC: Stateless IP/ICMP Translation for IPv6 Data Centre Environments
draft-anderson-v6ops-siit-dc-01
Document | Type |
Replaced Internet-Draft
(v6ops WG)
Expired & archived
|
|
---|---|---|---|
Author | Tore Anderson | ||
Last updated | 2015-10-14 (Latest revision 2014-10-05) | ||
Replaces | draft-anderson-siit-dc | ||
Replaced by | draft-ietf-v6ops-siit-dc | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | Candidate for WG Adoption | |
Document shepherd | (None) | ||
IESG | IESG state | Replaced by draft-ietf-v6ops-siit-dc | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes SIIT-DC, an extension to Stateless IP/ICMP Translation (SIIT) [RFC6145] that makes it ideally suited for use in IPv6 data centre environments. SIIT-DC simultaneously facilitates IPv6 deployment and IPv4 address conservation. The overall SIIT-DC architecture is described, as well as guidelines for operators. Finally, the normative implementation requirements are described, as a list of additions and changes to SIIT [RFC6145].
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)