Flow split in Metro Area Network
draft-aoch-nvo3-flow-split-00

Document Type Expired Internet-Draft (individual)
Authors Zhonghua Chen  , Ting Ao 
Last updated 2018-01-04 (latest revision 2017-07-03)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-aoch-nvo3-flow-split-00.txt

Abstract

In the future, there will be some new application appeared known as 4K/8K high quality video or VR/AR application.These application needs high bandwidth and low lantacy.In order to meet these requirements, the flow model of traditional MAN should be changed. This article describes a new device using in MAN to support spliting DC's and Internet's flow, support to build edge DC in MAN and change MAN flow model from pipe type to umbrella type.

Authors

Zhonghua Chen (18918588897@189.cn)
Ting Ao (ao.ting@zte.com.cn)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)