PIM Join Attributes for LISP Environments

Document Type Replaced Internet-Draft (individual)
Last updated 2014-02-08
Replaced by draft-ietf-pim-join-attributes-for-lisp
Stream (None)
Intended RFC status (None)
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-pim-join-attributes-for-lisp
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This document defines two PIM Join/Prune attributes that support the construction of multicast distribution trees where the root and receivers are located in different LISP sites. These attributes allow the receiver site to select between unicast and multicast transport and to convey the receiver RLOC address to the control plane of the root xTR.


Jesus Arango (jearango@cisco.com)
Stig Venaas (stig@cisco.com)
Isidor Kouvelas (kouvelas@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)