Signaling Protocol to convey FEC Framework Configuration Information
draft-asati-fecframe-config-signaling-00
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Rajiv Asati | ||
Last updated | 2008-02-18 | ||
Replaced by | RFC 6695 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-fecframe-config-signaling | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
FEC Framework document [FECARCH] defines the FEC Framework Configuration Information necessary for the FEC framework operation. This document describes one signaling protocol to determine and communicate the Configuration information between sender(s) and receiver(s). Conventions used in this document In examples, "C:" and "S:" indicate lines sent by the client and server respectively. The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119].
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)