Traffic Engineering & QoS Methods for IP-,ATM-,& TDMased Multiservice Networks
draft-ash-te-qos-routing-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Gerald Ash | ||
| Last updated | 2000-07-07 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The draft describes, analyzes, and recommends traffic engineering (TE) methods which control a network's response to traffic demands and other stimuli, such as link failures or node failures. These TE methods include: *traffic management through control of routing functions, which include call routing (number/name translation to routing address), connection routing, QoS resource management, routing table management, and dynamic transport routing. *capacity management through control of network design. *TE operational requirements for traffic management and capacity management, including forecasting, performance monitoring, and short-term network adjustment. These TE methods are recommended for application across network types based on established practice and experience.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)