Dynamic Path Selection (DPS) Based on Application
draft-aumuganainar-rtg-dps-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Arun Arumuganainar | ||
Last updated | 2014-03-26 (Latest revision 2013-09-22) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The document describes a network design architecture for routing packets via different paths available in the network based on application port number. Primarily, this is targeted for Enterprise customers who have built up redundancy at their WAN edge but are suffering from a congested primary link whilst the secondary is idle. The objective of this architecture is as follows 1) Offload bulky application on to the secondary link 2) Achieve the above with out introducing asymmetric routing in the network
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)