String Profile for iSCSI Names
draft-bakke-iscsi-stringprep-01

Document Type Expired Internet-Draft (individual)
Last updated 2001-11-15
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-bakke-iscsi-stringprep-01.txt

Abstract

The iSCSI protocol provides a way for hosts to access SCSI devices over an IP network. The iSCSI end-points, called initiators and targets, each have a globally-unique name that must be transcribable, as well as easily compared. This document describes how to prepare internationlized iSCSI names to increase the likelihood that name input and comparison work in ways that make sense for typical users throughout the world.

Authors

Mark Bakke (mbakke@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)