BGP Session Security Requirements
draft-behringer-bgp-session-sec-req-02
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Michael H. Behringer | ||
Last updated | 2007-08-09 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The document "BGP security requirements" (draft-ietf-rpsec-bgpsecrec) specifies general security requirements for BGP. However, specific security requirements for single BGP sessions, i.e., the connection between two BGP peers, are only touched on briefly in the section "transport layer protection". This document expands on this particular aspect of BGP security, defining the security requirements between two BGP peers.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)