Mesh Under IPv6 Routing Requirements
draft-beroset-ietf-1hop-routing-reqs-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Edward Beroset | ||
Last updated | 2010-09-16 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Wireless mesh routing for low cost wireless mesh devices can be done at a layer under IPv6. This document examines the functional requirements of this kind of routing and to explore why this approach might be used in some contexts. It should be noted that this kind of routing is orthogonal to IP-level routing; there is no inherent conflict between the two.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)