Diameter Specification Recommendations
draft-bertz-dime-diamimpr-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Lyle Bertz | ||
Last updated | 2018-07-16 (Latest revision 2017-12-30) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document reports on formatting errors, uses cases, and inconsistencies found in various standards specifications related to the Diameter interface requirements. Recommendations are made to reduce errors, support common use cases and build specifications in such a way that programmatic verification of Diameter specifications can be done with minimal to no errors.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)