Asynchronous Management Protocol Agent Application Data Model
draft-birrane-dtn-adm-agent-02

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Last updated 2016-12-31 (latest revision 2016-06-29)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-birrane-dtn-adm-agent-02.txt

Abstract

This document describes an Application Data Model (ADM) for an Asynchronous Management Protocol (AMP) Agent. The AMP Agent represents a managed device in the Asynchronous Management Architecture. This ADM identifies the Externally Defined Data, Variables, Report Templates, Controls, Macros, Literals, Operators, and meta-data associated with an Agent. The information outlined in this document MUST be supported by any software claiming to act as a managed device within the AMP.

Authors

Edward Birrane (edward.birrane@jhuapl.edu)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)