Learn NAT64 PREFIX64s using PCP
draft-boucadair-pcp-nat64-prefix64-option-02
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Mohamed Boucadair | ||
Last updated | 2013-03-12 (Latest revision 2012-09-12) | ||
Replaced by | draft-ietf-pcp-nat64-prefix64 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-pcp-nat64-prefix64 | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines a new PCP Option/OpCode to learn the Prefix64(s) used by a PCP-controlled NAT64 device to build IPv4- embedded IPv6 addresses. This Option/OpCode is needed for successful communications when IPv4 addresses are used in referrals (e.g., SIP).
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)