Procedure to bypass DS-Lite AFTR
draft-boucadair-softwire-cgn-bypass-03

Document Type Expired Internet-Draft (individual)
Authors Mohamed Boucadair  , Christian Jacquenet  , Jun Song  , Qibo Niu 
Last updated 2010-10-08
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-boucadair-softwire-cgn-bypass-03.txt

Abstract

This document proposes a solution to avoid the use of two stateful DS-Lite AFTR devices when both end-points are located behind different AFTR devices. For this purpose a new IPv6 extension header, called Tunnel Endpoint Extension Header (TEEH), is defined. The proposed procedure encourages the use of IPv6 between DS-Lite AFTR nodes as a means to avoid the unnecessary crossing of AFTR devices. A Flow Label based solution is also described.

Authors

Mohamed Boucadair (mohamed.boucadair@orange-ftgroup.com)
Christian Jacquenet (christian.jacquenet@orange-ftgroup.com)
Jun Song (song.jun@zte.com.cn)
Qibo Niu (niu.qibo@zte.com.cn)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)