Requirements for Extending IPv6 Addressing with Port Sets
draft-boucadair-softwire-stateless-requirements-00

Document Type Expired Internet-Draft (individual)
Authors Congxiao Bao  , Mohamed Boucadair  , Nejc Skoberne  , Xing Li 
Last updated 2012-03-26 (latest revision 2011-09-08)
Replaces draft-boucadair-softwire-stateless-rfc6052-update
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-boucadair-softwire-stateless-requirements-00.txt

Abstract

This document identifies a set of requirements to be taken into consideration in the design of stateless 4/6 solutions. In particular, these requirements cover the way IPv4-embedded IPv6 address and prefix are to be built when embedding the port information. A companion effort, documented at [I-D.bsd-softwire-stateless-port-index-analysis], is required to converge on one or a set of algorithms to be used by all stateless solutions.

Authors

Congxiao Bao (congxiao@cernet.edu.cn)
Mohamed Boucadair (mohamed.boucadair@orange-ftgroup.com)
Nejc Skoberne (nejc@viris.si)
Xing Li (xing@cernet.edu.cn)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)