Requirements for Extending IPv6 Addressing with Port Sets
draft-boucadair-softwire-stateless-requirements-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Congxiao Bao , Mohamed Boucadair , Nejc Skoberne , Xing Li | ||
| Last updated | 2012-03-26 (Latest revision 2011-09-08) | ||
| Replaces | draft-boucadair-softwire-stateless-rfc6052-update | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document identifies a set of requirements to be taken into consideration in the design of stateless 4/6 solutions. In particular, these requirements cover the way IPv4-embedded IPv6 address and prefix are to be built when embedding the port information. A companion effort, documented at [I-D.bsd-softwire-stateless-port-index-analysis], is required to converge on one or a set of algorithms to be used by all stateless solutions.
Authors
Congxiao Bao
Mohamed Boucadair
Nejc Skoberne
Xing Li
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)