EVPN-VPWS Service Edge Gateway

Document Type Expired Internet-Draft (individual)
Last updated 2018-01-01 (latest revision 2017-06-30)
Stream (None)
Intended RFC status (None)
Expired & archived
plain text pdf html bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This document describes how a service node can dynamically terminate EVPN virtual private wire transport service (VPWS) from access nodes and offer Layer 2, Layer 3 and Ethernet VPN overlay services to Customer edge devices connected to the access nodes. Service nodes using EVPN will advertise to access nodes the L2, L3 and Ethernet VPN overlay services it can offer for the terminated EVPN VPWS transport service. On an access node an operator can specify the L2 or L3 or Ethernet VPN overlay service needed by the customer edge device connected to the access node that will be transported over the EVPN- VPWS service between access node and service node.


Sami Boutros (sboutros@vmware.com)
Patrice Brissette (pbrisset@cisco.com)
Ali Sajassi (sajassi@cisco.com)
daniel.voyer@bell.ca (daniel.voyer@bell.ca)
John Drake (jdrake@juniper.net)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)