DHCP and DHCPv6 Options for the Port Control Protocol (PCP)
draft-bpw-pcp-dhcp-04

Document Type Replaced Internet-Draft (individual)
Authors Mohamed Boucadair  , Reinaldo Penno  , Dan Wing 
Last updated 2011-04-27
Replaces draft-bpw-softwire-pcp-dhcp
Replaced by RFC 7291
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-pcp-dhcp
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-bpw-pcp-dhcp-04.txt

Abstract

This document specifies DHCP (IPv4 and IPv6) options to configure hosts with Port Control Protocol (PCP) Server addresses. The use of IPv4 DHCP or DHCPv6 depends on the PCP deployment scenario.

Authors

Mohamed Boucadair (mohamed.boucadair@orange-ftgroup.com)
Reinaldo Penno (rpenno@juniper.net)
Dan Wing (dwing@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)