Home Automation Routing Requirement in Low Power and Lossy Networks
draft-brandt-rl2n-home-routing-reqs-02

Document Type Expired Internet-Draft (individual)
Author Vasseur Jp 
Last updated 2007-11-12
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
plain text pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-brandt-rl2n-home-routing-reqs-02.txt

Abstract

This document presents the home control and automation application specific requirements for Routing in Low power and Lossy Networks (RL2N). In a modern home, a high number of wireless devices are used for a wide set of purposes. Examples include lighting control modules, heating control panels, light sensors, temperature sensors, gas/water leak detector, motion detectors, video surveillance, healthcare systems and advanced remote controls. Because such devices only cover a limited radio range, multi-hop routing is often required. Such devices are usually highly constrained in terms of resources such as battery and memory and operate in unstable environments. The aim of this document is to specify the routing requirements for networks comprising such constrained devices in a home network environment.

Authors

Vasseur Jp (jpv@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)