EVPN-VPWS Seamless Integration with Legacy VPWS
draft-brissette-bess-vpws-seamless-00

Document Type Replaced Internet-Draft (individual)
Last updated 2019-10-31
Replaced by draft-brissette-bess-evpn-vpws-seamless
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-brissette-bess-evpn-vpws-seamless
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-brissette-bess-vpws-seamless-00.txt

Abstract

This document specifies mechanisms for backward compatibility of Ethernet VPN Virtual Private Wire Service (EVPN-VPWS) solutions with legacy Virtual Private Wire Service (VPWS). It provides mechanisms for seamless integration in the same MPLS/IP network on a per- pseudowire or per-flexible-crossconnect basis. Implementation of this document enables service providers to introduce EVPN-VPWS PEs in their brown-field deployments of leagcy VPWS networks. This document specifies control-plane and forwarding behavior needed for auto- discovery of a pseudowire in order to enable seamless integration between EVPN-VPWS and VPWS PEs.

Authors

Patrice Brissette (pbrisset@cisco.com)
Ali Sajassi (sajassi@cisco.com)
LucAndré Burdet (lburdet@cisco.com)
Jim Uttaro (uttaro@att.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)