File Transfer Protocol RANG Command for Byte Ranges
draft-bryan-ftp-range-03
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
---|---|---|---|
Authors | Anthony Bryan , Tatsuhiro Tsujikawa , Daniel Stenberg | ||
Last updated | 2011-03-14 (Latest revision 2011-02-01) | ||
RFC stream | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The File Transfer Protocol offers the REST command to designate a starting point for a transfer, but does not currently offer any method to specify an end point. This document specifies a new FTP RANG command to be used by clients to designate a start and end point to permit restarts and repairs of interrupted data transfers in STREAM mode.
Authors
Anthony Bryan
Tatsuhiro Tsujikawa
Daniel Stenberg
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)