File Transfer Protocol RANG Command for Octet Ranges
draft-bryan-ftp-range-06

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Last updated 2012-11-25 (latest revision 2012-05-24)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-bryan-ftp-range-06.txt

Abstract

The File Transfer Protocol offers the REST command to designate a starting point for a transfer, but does not currently offer any method to specify an end point. This document specifies a new FTP RANG command to be used by clients to designate a start and end point to permit restarts and repairs of interrupted data transfers in STREAM mode.

Authors

Anthony Bryan (anthonybryan@gmail.com)
Tatsuhiro Tsujikawa (tatsuhiro.t@gmail.com)
Daniel Stenberg (daniel@haxx.se)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)