MPLS Performance Measurement UDP Return Path
draft-bryant-mpls-oam-udp-return-02

Document Type Replaced Internet-Draft (mpls WG)
Authors Stewart Bryant  , Siva Sivabalan  , Sagar Soni 
Last updated 2014-07-03
Replaced by draft-ietf-mpls-pm-udp-return
Stream Internent Engineering Task Force (IETF)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream WG state Adopted by a WG
Document shepherd Loa Andersson
IESG IESG state Replaced by draft-ietf-mpls-pm-udp-return
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-bryant-mpls-oam-udp-return-02.txt

Abstract

This document specifies the proceedure to be used by the Packet Loss and Delay Measurement for MPLS Networks protocol defined in RFC6374 when sending and processing MPLS performance management out-of-band responses for delay and loss measurements over an IP/UDP return path.

Authors

Stewart Bryant (stbryant@cisco.com)
Siva Sivabalan (msiva@cisco.com)
Sagar Soni (sagsoni@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)