Application of PWE3 to MPLS Transport Networks
draft-bryant-pwe3-mpls-transport-00
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Stewart Bryant | ||
Last updated | 2008-10-27 (Latest revision 2006-10-16) | ||
Replaced by | draft-ietf-pwe3-mpls-transport | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-pwe3-mpls-transport | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
A need has been identified to identify a strict subset of the PWE3 over MPLS pseudowire functionality suitable for the construction of transport networks. This draft describes the IETF recommended profile for such cases. This document describes the IETF-recommended profile for such a configuration. In particular the profile of an RFC4448 PWE3 Ethernet pseudowire that can be used to address these requirements is described.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)