Delay-Tolerant Networking LTP Convergence Layer (LTPCL) Adapter
draft-burleigh-dtnrg-ltpcl-03
The information below is for an old version of the document.
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
---|---|---|---|
Author | Scott Burleigh | ||
Last updated | 2011-02-16 (Latest revision 2010-08-20) | ||
RFC stream | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes the procedures by which the Licklider Transmission Protocol (LTP) is used as a "convergence-layer" protocol to convey Delay-Tolerant Networking (DTN) "bundles" between DTN nodes.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)