Architectural Considerations for Diameter Load Information
draft-campbell-dime-load-considerations-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Ben Campbell , Steve Donovan , Jean-Jacques Trottin | ||
Last updated | 2015-09-10 (Latest revision 2015-03-09) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
RFC 7068 describes requirements for Overload Control in Diameter. This includes a requirement to allow Diameter nodes to send "load" information, even when the node is not overloaded. The Diameter Overload Information Conveyance (DOIC) solution describes a mechanism meeting most of the requirements, but does not currently include the ability to send load information. This document explores some architectural considerations for a mechanism to send Diameter load information.
Authors
Ben Campbell
Steve Donovan
Jean-Jacques Trottin
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)