The U and G bits in IPv6 Interface Identifiers
draft-carpenter-6man-ug-01
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Brian E. Carpenter , Sheng Jiang | ||
| Last updated | 2013-05-10 (Latest revision 2013-02-21) | ||
| Replaced by | draft-ietf-6man-ug | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-6man-ug | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The IPv6 addressing architecture defines a method by which the Universal and Group bits of an IEEE link-layer address are mapped into an IPv6 unicast interface identifier. This document clarifies the status of those bits for interface identifiers that are not derived from an IEEE link-layer address, and updates RFC 4291 accordingly.
Authors
Brian E. Carpenter
Sheng Jiang
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)