Use of the IPv6 Flow Label for WLCG Packet Marking
draft-cc-v6ops-wlcg-flow-label-marking-03
| Document | Type |
Expired Internet-Draft
(v6ops WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | Dale W. Carder , Tim Chown , Shawn McKee , Marian Babik | ||
| Last updated | 2025-01-04 (Latest revision 2024-07-03) | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | Dead WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes an experimentally deployed approach currently used within the Worldwide Large Hadron Collider Computing Grid (WLCG) to mark packets with their project (experiment) and application. The marking uses the 20-bit IPv6 Flow Label in each packet, with 15 bits used for semantics (community and activity) and 5 bits for entropy. Alternatives, in particular use of IPv6 Extension Headers (EH), were considered but found to not be practical. The WLCG is one of the largest worldwide research communities and has adopted IPv6 heavily for movement of many hundreds of PB of data annually, with the ultimate goal of running IPv6 only.
Authors
Dale W. Carder
Tim Chown
Shawn McKee
Marian Babik
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)