New Spin bit enabled measurements with one or two more bits
draft-cfb-ippm-spinbit-new-measurements-01

Document Type Replaced Internet-Draft (individual)
Last updated 2019-07-01
Replaced by draft-cfb-tsvwg-spinbit-new-measurements
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-cfb-tsvwg-spinbit-new-measurements
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-cfb-ippm-spinbit-new-measurements-01.txt

Abstract

This document introduces additional measurements by using the same spin bit signal as defined in [I-D.trammell-ippm-spin]. The spin bit signal alone is not enough to evaluate correctly in every network condition the RTT of a flow. In order to solve this problem, it is theorized the possibility of introducing an additional validation signal called delay bit, similar to what is done done by the Valid Edge Counter (VEC), but using just one bit instead of two. An alternative with two bits is also introduced with a so called loss bit.

Authors

Mauro Cociglio (mauro.cociglio@telecomitalia.it)
Giuseppe Fioccola (giuseppe.fioccola@huawei.com)
Fabio Bulgarella (fabio.bulgarella@guest.telecomitalia.it)
Riccardo Sisto (riccardo.sisto@polito.it)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)