LowPan Mobility Requirements and Goals
draft-chakrabarti-mobopts-lowpan-req-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Soohong Daniel Park , Samita Chakrabarti | ||
| Last updated | 2007-03-07 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
IETF LowPan working group defines IPv6 over low-power personal area network (IEEE 802.15.4). Lowpan architecture allows routing to take place at the link layer in order to save payload overhead over the IEEE 802.15.4 link and thus more efficient routing for low power, low data-rate networks such as sensor networks. This document discusses a few scenarios of mobility in LowPan network and states mobility requirements and goals for LowPan networks.
Authors
Soohong Daniel Park
Samita Chakrabarti
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)