IS-IS BFD Enabled TLV
draft-chopps-isis-bfd-tlv-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Les Ginsberg | ||
| Last updated | 2007-11-19 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a TLV for use in the IS-IS routing protocol that allows for the proper use of the Bidirectional Forwarding Detection protocol (BFD). There exist certain scenarios in which IS-IS will not react appropriately to a BFD detected forwarding plane failure without use of either this TLV or some other method.Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119].
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)