PCEP Extensions for PCE-initiated LSP Setup in a Stateful PCE Model
draft-crabbe-pce-pce-initiated-lsp-03

Document Type Expired Internet-Draft (individual)
Last updated 2014-04-14 (latest revision 2013-10-11)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
plain text pdf html bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-crabbe-pce-pce-initiated-lsp-03.txt

Abstract

The Path Computation Element Communication Protocol (PCEP) provides mechanisms for Path Computation Elements (PCEs) to perform path computations in response to Path Computation Clients (PCCs) requests. The extensions described in [I-D.ietf-pce-stateful-pce] provide stateful control of Multiprotocol Label Switching (MPLS) Traffic Engineering Label Switched Paths (TE LSP) via PCEP, for a model where the PCC delegates control over one or more locally configured LSPs to the PCE. This document describes the creation and deletion of PCE- initiated LSPs under the stateful PCE model.

Authors

Edward Crabbe (edc@google.com)
Ina Minei (ina@juniper.net)
Siva Sivabalan (msiva@cisco.com)
Robert Varga (robert.varga@pantheon.sk)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)