Skip to main content

Use Cases and Requirements for MPLS-TP multi-failure protection

Document Type Replaced Internet-Draft (mpls WG)
Expired & archived
Authors Zhenlong Cui , Rolf Winter , Himanshu C. Shah , Sam Aldrin , Masahiro Daikoku
Last updated 2016-01-12
Replaced by draft-ietf-mpls-tp-mfp-use-case-and-requirements
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status (None)
Additional resources Mailing list discussion
Stream WG state Adopted by a WG
Document shepherd Loa Andersson
IESG IESG state Replaced by draft-ietf-mpls-tp-mfp-use-case-and-requirements
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:


For the Multiprotocol Label Switching Transport Profile (MPLS-TP) linear protection capable of 1+1 and 1:1 protection has already been defined. That linear protection mechanism has not been designed for handling multiple, simultaneously occuring failures, i.e. multiple failures that affect the working and the protection entity during the same time period. In these situations currently defined protection mechanisms would fail. This document introduces use cases and requirements for mechanisms that are capable of protecting against such failures. It does not specify a multi-failure protection mechanism itself.


Zhenlong Cui
Rolf Winter
Himanshu C. Shah
Sam Aldrin
Masahiro Daikoku

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)