IS-IS Flooding Parameters advertisement
draft-decraene-lsr-isis-flooding-speed-05
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
|---|---|---|---|
| Authors | Bruno Decraene , Chris Bowers , Jayesh , Tony Li , Gunter Van de Velde | ||
| Last updated | 2021-05-02 (Latest revision 2020-10-29) | ||
| Replaced by | draft-decraeneginsberg-lsr-isis-fast-flooding | ||
| RFC stream | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document proposes a mechanism to adjust IS-IS flooding speed between two adjacent routers by adjusting the sender flooding speed to the capability of the receiver. This helps improving the flooding throughput, reducing LSPs losses and retransmissions due to receiver overload, and avoiding manual tuning of flooding parameters by the network operator. This document defines a new TLV for SNP and/or Hello messages. This TLV may carry a set of parameters indicating the performance capacity to receive LSPs.
Authors
Bruno Decraene
Chris Bowers
Jayesh
Tony Li
Gunter Van de Velde
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)