RTP Payload Format for MELPe Codec
draft-demjanenko-payload-melpe-04
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Victor Demjanenko , David Satterlee | ||
| Last updated | 2015-09-22 | ||
| Replaced by | draft-ietf-payload-melpe | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-payload-melpe | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes the RTP payload format for the Mixed Excitation Linear Prediction Enhanced (MELPe) speech coder algorithm developed by Atlanta Signal Processing (ASPI), Texas Instruments (TI), SignalCom (now Microsoft) and Thales Communications with noise preprocessor contributions from AT&T under contract with NSA/DOD as international NATO Standard STANAG 4591. All three different speech encoding rates and sample frames sizes are included. Comfort noise procedures and packet loss concealment are detailed. Also, within the document there are included necessary details for the use of MELP with SDP.
Authors
Victor Demjanenko
David Satterlee
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)