DetNet Packet Jitter, Bandwidth and Misordering Passive Performance Measurement
draft-detnet-jitter-bandwidth-misordering-00

Document Type Expired Internet-Draft (individual)
Last updated 2019-11-18 (latest revision 2019-05-06)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-detnet-jitter-bandwidth-misordering-00.txt

Abstract

Deterministic Networking (DetNet) can provide data transmission with end-to-end bounded latency and extremely low packet loss for user's services. In order to better control and manage deterministic network services. It is necessary to measure and monitor DetNet QoS information. As introduced in [I-D.chen-detnet-loss-delay], packet loss rates and end-to-end delay can be measured by using passive Performance Measurement (PM) in MPLS-based DetNet encapsulation. This document implement three new QoS related attribute to support passive Performance Measurement for DetNet service.

Authors

Liquan Chen (lqchen@seu.edu.cn)
Sijie Qian (sijieqian@foxmail.com)
Ting Ao (ao.ting@zte.com.cn)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)