A YANG model to manage the optical interface parameters for an external transponder in a WDM network
draft-dharini-ccamp-dwdm-if-param-yang-06
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Gabriele Galimberti , Ruediger Kunze , Dharini Hiremagalur , Gert Grammel | ||
| Last updated | 2018-10-22 | ||
| Replaces | draft-dharini-ccamp-dwdm-if-yang | ||
| Replaced by | draft-ietf-ccamp-dwdm-if-param-yang | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Yang Validation | ☯ 0 errors, 0 warnings | ||
| Additional resources |
Yang catalog entry for ietf-ext-xponder-wdm-if@2018-10-22.yang
Yang impact analysis for draft-dharini-ccamp-dwdm-if-param-yang |
||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-ccamp-dwdm-if-param-yang | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo defines a Yang model related to the Optical Transceiver parameters characterising coherent 100G and above interfaces. 100G and above Transceivers support coherent modulation, multiple modulation formats, multiple FEC codes including some not yet specified (or by in phase of specification by) ITU-T G.698.2 [ITU.G698.2] or any other ITU-T recommendation. More context about the state of the Coherent transceivers is described in draft-many- coherent-DWDM-if-control. Use cases are described in RFC7698 The Yang model defined in this memo can be used for Optical Parameters monitoring and/or configuration of the endpoints of a multi-vendor IaDI optical link. The use of this model does not guarantee interworking of transceivers over a DWDM. Optical path feasibility and interoperability has to be determined by means outside the scope of this document. The purpose of this model is to program interface parameters to consistently configure the mode of operation of transceivers.
Authors
Gabriele Galimberti
Ruediger Kunze
Dharini Hiremagalur
Gert Grammel
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)