MPL Parameter Configuration Option for DHCPv6
draft-doi-roll-mpl-parameter-configuration-04

The information below is for an old version of the document
Document Type Active Internet-Draft (individual)
Authors Yusuke Doi  , Matthew Gillmore 
Last updated 2014-02-13
Replaced by RFC 7774, RFC 7774
Stream (None)
Intended RFC status (None)
Formats pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state I-D Exists
Telechat date
Responsible AD (None)
Send notices to (None)
roll                                                              Y. Doi
Internet-Draft                                       TOSHIBA Corporation
Intended status: Standards Track                             M. Gillmore
Expires: August 17, 2014                                      Itron, Inc
                                                       February 13, 2014

             MPL Parameter Configuration Option for DHCPv6
             draft-doi-roll-mpl-parameter-configuration-04

Abstract

   This draft is to define a way to configure MPL parameter via DHCPv6
   option.

Status of this Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at http://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on August 17, 2014.

Copyright Notice

   Copyright (c) 2014 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Doi & Gillmore           Expires August 17, 2014                [Page 1]
Internet-Draft            MPL Conf. for DHCPv6             February 2014

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . . . 3
   2.  MPL Parameter Configuration Option  . . . . . . . . . . . . . . 3
     2.1.  Unsigned Short Floating Point . . . . . . . . . . . . . . . 4
     2.2.  MPL Parameter Configuration Option Format . . . . . . . . . 5
     2.3.  DHCPv6 Client Behavior  . . . . . . . . . . . . . . . . . . 6
     2.4.  MPL Forwarder Behavior  . . . . . . . . . . . . . . . . . . 6
     2.5.  DHCPv6 Server Behavior  . . . . . . . . . . . . . . . . . . 7
     2.6.  DHCPv6 Relay Behavior . . . . . . . . . . . . . . . . . . . 7
   3.  IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 7
   4.  Security Considerations . . . . . . . . . . . . . . . . . . . . 7
   5.  References  . . . . . . . . . . . . . . . . . . . . . . . . . . 8
     5.1.  Normative References  . . . . . . . . . . . . . . . . . . . 8
     5.2.  Non-Normative References  . . . . . . . . . . . . . . . . . 8
   Appendix A.  Update History . . . . . . . . . . . . . . . . . . . . 8
   Appendix B.  Acknowledgements . . . . . . . . . . . . . . . . . . . 9
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . . . 9

Doi & Gillmore           Expires August 17, 2014                [Page 2]
Internet-Draft            MPL Conf. for DHCPv6             February 2014

1.  Introduction

   Multicast Protocol for Low power and Lossy Networks (MPL)
   [I-D.ietf-roll-trickle-mcast] defines a protocol to make a multicast
   network among low power and lossy network i.e. wireless mesh
   networks.  MPL has various parameters to control its behavior and
   tradeoff between end-to-end delay and network utilization.  In some
   environments, the parameters shall be configured carefully to meet
   each environment and requirement.  According to the MPL draft section
   5.4, the parameter should be same for all nodes within an MPL domain.
   And the MPL draft does not define a method to configure it.

   Some managed wireless mesh networks may have a DHCP server to
   configure network parameters with DHCP relay in each node.  MPL
   parameters shall be considered as a part of network parameters
   (parameter shall match within an MPL domain).  This document is to
   define the way to distribute parameters for MPL forwarders as a
   simple DHCPv6 [RFC3315] option.

2.  MPL Parameter Configuration Option

   Per MPL domain, there are following 10 parameters.  An MPL domain is
   defined by an MPL domain address.

   o  PROACTIVE_FORWARDING

   o  SEED_SET_ENTRY_LIFETIME

   o  DATA_MESSAGE_IMIN

   o  DATA_MESSAGE_IMAX

   o  DATA_MESSAGE_K

   o  DATA_MESSAGE_TIMER_EXPIRATIONS

   o  CONTROL_MESSAGE_IMIN

   o  CONTROL_MESSAGE_IMAX

   o  CONTROL_MESSAGE_K

   o  CONTROL_MESSAGE_TIMER_EXPIRATIONS

   One network may have multiple MPL domains with different
Show full document text