MPL Parameter Configuration Option for DHCPv6
draft-doi-roll-mpl-parameter-configuration-05
Document | Type |
Replaced Internet-Draft
(candidate for roll WG)
Expired & archived
|
|
---|---|---|---|
Authors | Yusuke Doi , Matthew Gillmore | ||
Last updated | 2014-03-09 (Latest revision 2014-03-05) | ||
Replaced by | draft-ietf-roll-mpl-parameter-configuration | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | Call For Adoption By WG Issued | |
Document shepherd | (None) | ||
IESG | IESG state | Replaced by draft-ietf-roll-mpl-parameter-configuration | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This draft defines a way to configure MPL parameter set via DHCPv6 option. MPL has a set of parameters to control its behavior, and the parameter set is often configured as a network-wide parameter because the parameter set should be identical for each MPL forwarder in an MPL domain. Using the MPL Parameter Configuration Option defined in this document, a network can be configured with a single set of MPL parameter easily.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)