Skip to main content

Advertising SRv6 SIDs for Layer 2 Bundle Member Links in IGP
draft-dong-lsr-l2bundle-srv6-01

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Active".
Expired & archived
Authors Jie Dong , Zhibo Hu
Last updated 2022-04-27 (Latest revision 2021-10-24)
RFC stream (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

There are deployments where the Layer-3 interface on which IGP operates is a Layer-2 interface bundle. Existing IGP advertisements only support advertising link attributes of the Layer-3 interface. If entities external to IGP wish to control traffic flows on the individual physical links that comprise the Layer-2 interface bundle, link attribute information about the bundle members is advertised by IGP extensions for Layer-2 (L2) bundle. When Segment Routing over IPv6 (SRv6) is used with Layer-2 interface bundle to control traffic flows on the individual member links, the SRv6 SIDs which represent the Layer 2 member links of the L2 bundle needs to be advertised in IGP. This document proposes the IGP extensions to advertise the SRv6 SIDs of the Layer 2 (L2) bundle member links.

Authors

Jie Dong
Zhibo Hu

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)