Diameter Agent Overload
draft-donovan-dime-agent-overload-03
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Steve Donovan | ||
| Last updated | 2014-11-10 | ||
| Replaced by | RFC 8581 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-dime-agent-overload | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This specification documents an extension to the Diameter Overload Control (DOC) base solution. The extension addresses the handling of occurrances of overload of a Diameter agent. Requirements
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)